Cómo eliminar el error de toner en la impresora OKI C5800

This probably won’t help if you have physical damage to the toner drum

• Just like all other instructions, get into the special menu by holding down the menu+ and menu- keys while turning the unit on.
• When you see the message «OKIUSER» CAREFULLY release both buttons at the same time.
• Use the menu- or the menu+ to get to «ENGINE DIAG MODE».
• Press enter. DIAGNOSTIC MODE XX.XX.XX will appear.
• Now press both the online and the back buttons, and «ENG DIAG LEVEL 4» will be displayed.
• Press enter.
• Press menu+ twice to «ENGINE PARAMETER SET 2»
• Press enter.
• Press menu+ twice to get to «TONER SENSOR ENABLE» (with a * in the lower right hand of the display window.
• Press enter and the word «ENABLE» will begin to blink, indicating it can be changed.
• Press menu+ and the word will change to «DISABLE», still blinking. This is a toggle, make sure to not hit the button twice.
• This is the important step: simultaneously press the online, cancel, and back buttons, and let them all go simultaneously. this sets your selection.
• There are other things that can be done here in the same fashion, but that is out of the scope of this document.
• Use the «BACK» and the «MENU-» keys to back out all the way to the message «INITIALIZING», then power off, wait 10 seconds, and power back on.